This is a Factory OEM (Original Equipment Manufacturer) Oldsmobile 2 Button keyless entry remote, aka "key fob".
Oldsmobile
- 1997 Oldsmobile Silhouette
- 1996 Oldsmobile Silhouette
- 1995 Oldsmobile Silhouette
- 1994 Oldsmobile Silhouette
- 1993 Oldsmobile Silhouette
- 1992 Oldsmobile Silhouette
- 1991 Oldsmobile Silhouette
- 1990 Oldsmobile Silhouette
Obtain all remote transmitters for this vehicle.
1. Insert key into ignition and turn ignition switch to the ON position (as far as you can turn without cranking engine).
2. Lower glove box and remove the inner compartment. You must access behind the glove box. Once removed locate the receiver box behind glove box and press the "PROGRAM" button on the receiver.
3. Once pressed the vehicle will automatically cycle the door locks to lock and then unlock.
4. Vehicle is now in programming mode. Within ten seconds, press the UNLOCK button once on the first remote to be programmed. Vehicle will cycle door locks again to lock then unlock to verify acceptance of the remote.
5. Repeat step 4 to program an additional remote.
6. Programming is now complete. Wait ten seconds after the last programmed remote, turn off ignition, and test remotes to ensure proper programming.
Obtain all remote transmitters for this vehicle.
1. Remove key from ignition.
2. Remove the MALL PGM/BCM PGM fuse from fuse box.
3. Close all doors.
4. Turn ignition switch to ACC. (ACC is turning the key back toward you).
5. Within 1 second turn the ignition to OFF then back to ACC. (OFF is the position where you can remove your key)
6. Open then close the drivers door.
7. An acoustic sound will be heard after closing the door indicating the vehicle is in programming mode.
8. Hold the LOCK and UNLOCK buttons on the remote for about 15 seconds until two chimes are heard.
9. Repeat step 8 for any additional remotes including working ones.
10. Remove key from ignition and replace MALL PGM fuse.
11. Test all remotes.
We are proud to offer true OEM key fobs direct to you at up to 80% off dealer prices. There is a catch though, so here it goes:
You need to know the only way to get a NEW OEM key fob is to go to a dealer or authorized reseller of OEM parts, and you will pay dealer prices if you do this and spend hundreds of dollars.
The key fob you are going to purchase from us is used or as we like to say "previously loved". We recycle OEM key fobs and put them through a rigorous refurbishing process so we can guarantee our products and offer them at a reasonable price along with saving the environment. Oh, and we are not robbing you of your hard earned dollars like the stealership does. So if you are good with all of this what are you waiting for? Make your life easier, order a key fob from us and save the world!
