This is a new aftermarket replacement key fob compatible with Ford Lincoln Mazda Mercury models listed below. This product meets our quality standards and is guaranteed to work the same as an original.

• 1999-2016 Ford E-150
• 1999-2016 Ford E-250
• 1999-2016 Ford E-350
• 2008-2016 Ford E-450
• 2007-2014 Ford Edge
• 2001-2014 Ford Escape
• 2002 Ford Escort
• 2000-2005 Ford Excursion
• 1998-2014 Ford Expedition
• 1998-2014 Ford Explorer
• 2001-2010 Ford Explorer Sport Trac
• 1998-2014 Ford F-150
• 1998-2014 Ford F-250
• 1998-2014 Ford F-350
• 2005-2007 Ford Freestyle
• 1998-2011 Ford Ranger
• 1998-2003 Ford Windstar
• 2006-2008 Lincoln Mark LT
• 1998-2003 Lincoln Navigator
• 2001-2009 Mazda B2300
• 1999-2001 Mazda B2500
• 1999-2008 Mazda B3000
• 1999-2009 Mazda B4000
• 2001-2011 Mazda Tribute
• 2005-2011 Mercury Mariner
• 2004-2007 Mercury Monterey
• 1998-2010 Mercury Mountaineer

*** THERE ARE 2 POSSIBLE PROGRAMMING PROCEDURES. ***

Procedure #1
Note: Obtain all remote transmitters for this vehicle.

Note: Do not depress the brake pedal during procedure.

1. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)

2. Within 20 seconds press any button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 4.

3. Within 20 seconds, press any button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 3. For all other remotes.

 

4. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.

Procedure #2
Note: Obtain all remote transmitters for this vehicle.

1. Fasten seat belts and close all doors.

2. Turn ignition from OFF to RUN 4 times within 6 seconds, with the 4th time ending in RUN. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)

3. Turn ignition to OFF. Acoustic signal will sound and system warning lamp will illuminate to confirm programming mode.

4. Within 10 seconds, press and hold any button on the first keyless remote. Wait for acoustic sound and warning lamp to flash (confirming programming) then release button on remote. Wait 2 seconds but within 10 seconds repeat step 4. For all other remotes. If you only have one remote then continue to step 5.

5. Turn ignition to Crank or wait 10 seconds to end programming mode.

 

An aftermarket remote or key is a product that is not associated with the brand of your vehicle. Because of this, they tend to be a bit cheaper than remotes and keys that come from your vehicle's manufacturer.

An aftermarket product will still sync up to your vehicle and work just like a regular remote or key, it just won't have your vehicle's logo.