This is a Factory OEM (Original Equipment Manufacturer) Honda Odyssey 4 Button keyless entry remote, aka "key fob".
Genuine OEM electronics in a new aftermarket case.

1996-2004 Honda Odyssey

Obtain all remote transmitters for this vehicle. Entering programming mode erases all remotes, so all remotes must be programmed during this procedure.

1. Turn ignition to ON (ll). (ON is the position just shy of starting the vehicle without cranking engine)
2. Press and hold the valet/disarm button located between the AM/FM and CD/TAPE button. The vehicle will respond by locking and unlocking the doors, indicating the vehicle is in programming mode. (You must continue to hold the valet button until instructed to release)
3. Within five seconds, press the LOCK or UNLOCK button on the remote. The vehicle will respond by locking and unlocking the doors, indicating the vehicle has programmed that remote.
4. Within ten seconds, Repeat step 3. for all additional remotes to be programmed.
5. Release valet/disarm button to exit programming mode. Test all remotes.

Obtain all remote transmitters for this vehicle and read the instructions prior to programming.

Entering programming mode will erase all previously programmed remotes for this vehicle. You must have all remotes available for programming including working ones.

• Enter vehicle and close all doors

• Each of the following steps must be completed within five seconds of completing the previous step. If you take longer than five seconds or make a mistake, you must start the entire procedure over.

• Insert the key into the ignition, hold one remote in your left hand with additional remotes close by. We recommend taking remotes off the key ring to perform the procedure. When the instructions say to press the LOCK button, you should press the LOCK button on the remote for approximately one second then release it.

Perform each of the next three steps in order, then repeat all three steps two more times for a total of three times each.

1. Turn the ignition to the ON position, marked II.
2. Press the LOCK button on the remote.
3. Turn the ignition to the OFF position, marked I. (Do steps 1-3 three times)

Next, turn the ignition switch to ON position, marked II.

4. Using the same remote, press the LOCK button again. The door locks should cycle indicating the vehicle has ENTERED programming mode.

5. Using the same remote, press the LOCK button again. The door locks should cycle indicating the vehicle has PROGRAMMED that remote.

If you have other remotes to program then repeat step 5 with each additional remote one after another. Step 5 must be completed within ten seconds for each additional remote. You may program up to three remotes.

6. Turn the ignition to OFF. Test all remotes.

If your remote has a trunk button you will need to hold that button down for several seconds for that function to operate.

OEM Key Fobs:

We are proud to offer true OEM key fobs direct to you at up to 80% off dealer prices. There is a catch though, so here it goes:

You need to know the only way to get a NEW OEM key fob is to go to a dealer or authorized reseller of OEM parts, and you will pay dealer prices if you do this and spend hundreds of dollars.

The key fob you are going to purchase from us is used or as we like to say "previously loved". We recycle OEM key fobs and put them through a rigorous refurbishing process so we can guarantee our products and offer them at a reasonable price along with saving the environment. Oh, and we are not robbing you of your hard earned dollars like the stealership does. So if you are good with all of this what are you waiting for? Make your life easier, order a key fob from us and save the world!